Use this source to create a single frequency, frequency modulated waveform.
Parameters
| Parameter | Description | Units | Default |
|---|---|---|---|
| DC | DC Amplitude of the source used in operating point analysis. | V or A | 0 |
| VO | DC offset voltage or current. Used to adjust the DC bias of the signal generator with respect to the negative terminal (usually ground). | V o A | |
| VA | Peak amplitude. | V o A | |
| FC | Carrier frequency. | Hz | |
| MDI | Modulation index. Value corresponding to a function of amplitude of the modulating signal indicating the level of modulation. MDI=(frequency deviation)/FS. | ||
| FS | Signal frequency. | Hz | |
| PHASEC | Carrier phase. | degree | |
| PHASES | Signal phase. | degree | |
| ACMAG | AC Magnitude of small signal voltage or current. Set this if you plan to do a small signal AC analysis based on this source. | V or A | |
| ACPHASE | AC Phase of small signal voltage or current. Set this if you plan to do a small signal AC analysis based on this source. If phase is omitted, a value of zero is assumed. | degrees | |
| DISTOF1 | Set this if you plan to do a distortion analysis based on this source. Specify the amplitude and phase using space as separator. If phase is omitted, a value of zero is assumed. | ||
| DISTOF2 | Set this if you plan to do a distortion analysis based on this source. Specify the amplitude and phase using space as separator. If phase is omitted, a value of zero is assumed. | ||