During the interactive simulation, you can change the inductance value by performing the following operations:
Click on the component to set. The component is highlighted. To select multiple components, press and hold the SHIFT key and click on the components to select.
-
Press the Left Arrow Key to decrease the value by 1%.
Press the Right Arrow Key to increase the value by 1%.
Press the Up Arrow key to increase the value by 10%.
Press the Down Arrow key to decrease the value by 10%.
Parameters
| Parameter | Description | Units | Default |
|---|---|---|---|
| Value | Inductor value in Henrys. Use the '/' character to separate the minimum value from the maximum value. e.g. 10µH/30µH. This value is used only if no value is specified for the parameters MINVALUE and MAXVALUE. | Henrys | |
| MinValue | Minimum value of inductance in Henrys. If omitted, the value specified in the component VALUE is used. | Henrys | 1µH |
| MaxValue | Maximum value of inductance in Henrys. If omitted, the value specified in the component VALUE is used. | Henrys | 100µH |
| Position | Cursor position in percent. Values from 0 (MINVALUE) to 100 (MAXVALUE). | 50 | |
| Type | Select the type of variation between linear and logarithmic. | Linear | |
| TSwitch | Switching time in seconds. Within the specified time, the inductance value varies continuously between the current value and the new value. Must be greater than zero. | Seconds | 1ms |
| IC | The initial condition is the initial (time-zero) value of inductor current. Note that the initial conditions apply 'only' if the UIC (Use Initial Condition) option is enabled in the Transient Analysis dialog box. This parameter is optional. | Amps |