This command allows you to create a copper area of any shape. In addition to simple linear segments, you can also include arcs and curves.

Example of how to draw a copper area

To draw the copper area shown above:

Choose the PCB » Copper » Filling » Polygon command or click the tool in the toolbar.
Position the mouse pointer and click on point (1) to start drawing the shape.
Complete the first segment by specifying its end point (2). You can use the pointing device or you can open the dialog box for entering values. In the dialog box, the coordinates of the endpoint can be specified as follows:
- By typing the point coordinates directly.
- By specifying the offset from the starting point.
- Specifying the inclination of the line relative to the horizontal axis and its length.
Activate the tool menu with the secondary mouse button and choose the Tool » Arc: Start, Center, End Angle command.
Move the mouse over point (3) and click to specify the center of the arc.
Activate the tool menu with the secondary mouse button and choose the Toggle direction command or press TAB.
Move the mouse over point (4) and click to specify the end point of the arc or press INS and specify an angle of 270°.
Activate the tool menu with the secondary mouse button and choose the command Tool » Line.
Drag the mouse to draw the next segment and click on the point (5).
Press ENTER to end the command.

Commands and options

To repeat the command press the SPACEBAR.
To close the tool without drawing the object press ESC.
To remove the last segment press BACKSPACE.
To change the direction of arc, press TAB.
To end the insertion of the points of a spline choose the command Ends the current segment in the tool menu.
Press ENTER to end the command.
To specify the coordinates of the points or the value of the lengths you can use the pointing device or you can press INS to open the dialog box for entering values.